ZVIZZER STANDARD PAD, HARD, RED Ø150/12/140MM

ZviZZer Standard Pad Hard is a red polishing pad with high abrasive power. Combined with the ZviZZer polishing agent Heavy Cut, this is the ideal combo to remove difficult corrections, large defects and hard coatings. Ideal to quickly remove deep scratches or sanding scratches quickly and efficiently. The paint will already have a nice shine but it is recommended to go over it again afterwards with the ZviZZer Medium Cut or Fine Cut to create extra shine.



This ZviZZer Standard polishing pad is specially designed for rotary polishers. The polishing pads have a thickness of 12mm which gives you more control and better power consideration while correcting the surface. This ZviZZer polishing pad is very easy to clean by using a brush or compressor. This will optimally extend the life of the polishing pad.


The ZviZZer polishing pads feature quality foam, open cell structure and specific glue between velcro and foam which makes the polishing pads last considerably longer than polishing pads from other brands.



If the surface is in very bad condition, with for example dull spots, deep scratches and burnt-in bird droppings then it is recommended to use the Zvizzer Doodle-Wool pad first to shorten the polishing time.



Features:

- Standard polishing pad

- Abrasiveness: coarse

- Color: red

- Foam size working surface: 150mm

- Velcro size: 140mm

- Thickness: 12mm

- Suitable for Backing Plate: 125mm

- Machine type: rotary



ZviZZer polishing pad features:

- Better power transfer

- Better control

- Better resistance to temperature rise (less deformation)

- High quality foam

- Easy to clean



ZviZZer is first and foremost a system entirely designed to simplify your work and avoid mistakes thanks to a common color code (red/orange/yellow/green) for pads, microfibers and polishes.



Sizes available for the STANDARD polishing pads ZviZZer series:

Sizes are expressed as follows (foam size work surface/pad thickness/ Velcro size)



Tip: When polishing a vehicle, it is very important that you always use 2 polishing pads. You then change those polishing pads after each panel so that they do not get overheated. An overheated pad will warp and the polish present will become too hot so it will no longer work efficiently.